al-yeti

Convertors only for the cvi stuff right? Most other or some recorders can do ip tvi an ahd ?

Lol no be serious, £65-100 They sold like hot cakes , to much hikvision on the market allows the stuff to sell

I bought loads of these of norbain couple years back maybe 200 at £15 each , sold them on eBay

Sounds like your going to need lots of liability insurance ?

No Only if panel nvm faulty so unlikely

I always over spec , buy in and use everything on next install , the next install I have also over spec, not by allot but a bit , then occasionally have to buy more in until I over spec again

Local jobs include it Otherwise agree something unless you got very good day rate regardless then can include fuel provided not having to travel every day , digs might work cheaper

Minimum you need is the Neg -ve Pos +12v - bell trigger And have the bell set to SCB mode , and make sure the bell tamper is correctly removed , I think you need the switch though for bell to work

What about the negative ? You still need it

Why not just remove mains and battery and let it restart?

What did you programme it as , you have a meter to see what output is doing?

So you moved the router ?

And the classic is most classes either online or they watch recorded lessons or go once or twice a week , that way numbers and capacity is up , they make more money and dish out the degrees Probably good what they done with the GCSE grading system , only pandemic had delayed it a little , atleast it will correct all these a stars that every student seems to get

I thought it had become that, definitely not the cream going to uni these days , anyone can get a degree and anyone can get a master's

Actually opto relays , I couldn't be bothered to see what and how they work in the panel other than that optical relays work similar

James is pointing out that your connecting to a relay which unless wired correctly will do nothing Assuming the relay is triggered on alarm the no can stay in the bell trigger , but the c (common needs to connect to negative or minus or -ve ) that way when the alarm triggers it will connect the bell trigger to the negative it requires to ring it Strobe I am not sure , the other outputs are programmable perhaps and you need to look at menus what they can do

Fault in panel? Rf rx/tx switched off faulty

So I assume a plain switch at the DVR end allows everything to work , £10 or so Then just stick the other router on another output for wifi

Worse than visonic ......

What dvr?

Yes but a version that can do that , should be able to use existing sensors

To be honest I can't see how you will do it Basic panel with no area settings??? Home mode and delay1 ,2 etc seem to only have certain options What are you arming on home mode ?

So home mode , you don't want to arm the front door only other sensors get armed?

Option 62 b exit 0 timed low tone 1 instant set 2 silent 3 copy A settings or something like that Maybe