al-yeti

Diy , one way scantronic ion range with free app base Everything else will be junk or need installer or tech support Unless someone else remembers anything else Otherwise going to the depths of diy ring?

Diy?

It's old panel dude , just like anything else it may do the job if it works for a bit , but realistically I am sure as SW would say not using a Nokia version 1 to post your messages ....... DIY although one way I can only say go scantronics ion which still uses a free based app system and is less complication other systems Others that are free either poor hardware or complicated programming

Reprogramming it all is best , to make sure it all works to how you want it to, but If you got the budget get rid of it when you can

Don't you have to set the zones up for part set first? In settings ? Then that might work ?

Keypad tamper is open

Lol , I here Sia will fit a decent dimension

Hkc SIA secure it all https://secureitall.co.uk/

No from what I know, but I was thinking he wired the loop wrong so back to start

As above G2-12 or whatever size you need?

So disconnect everything and close the tamper loop aswell that way you know everything is how it should be

Nah man that's just odd companies that do that, Different code and lock all panels is best ?

As jw , but pay him to default codes and lose all support from him or them ....

You missed some settings If your pirs are not using a common tamper loop you must set the zone eol section on the panel accordingly option 21? And if there was no bell tamper problem previously then you have wired the bell tamper incorrectly , or there never was a bell tamper and you haven't closed the loop , you picture of bell connections before swap and after?

So the mesh would work? If you place the receiver in an IP box outside each building for the intruder ? Texecom? 25m

How much movement and why can't you secure them better ?

Unless he uses ha system which provides that but decent stuff might cost 40k ?

Depends , if you had remote switch couple of nvrs your wouldn't want a cat5 between them right ?

All of them?

Inputs and relay output? So in menu when something on camera is programmed it will or can cause those outputs to activate Crudely speaking , camera 1 video loss, has alarm beeps recorder but switch an out put or relay to do something, maybe trigger another device or whatever you want it to do Experts will correct me when they wake up , get out of bed and get real jobs .....

So you may as well do ring then right? Although there are a few others who do the door ell and cameras , hik, ezviz(same as him) or whatever it's called

Keypads probably worth the most if you can wait it out....

How far ?

I think your link is correct black intact and the others are cut So has to be a switching issue or incorrect tamper wiring Or your bell trigger is incorrect What happens if you disconnect the bell trigger and close it all up , does it stop ringing ?

Those connections are in the galaxy 60? So assuming your tamper circuit is always open?