al-yeti

Unless panel is locked won't do anything And you understand if it isn't locked and you default , everything will default and you will have to programme from scratch! Or you trying to default codes only , defaulting info isn't given out on this forum by the way Why not just get the original installer to reset for you? Otherwise you may run into lots of.problems

Might be Press prog Enter existing code Press 8 Four zones light up Enter new code Press reset New code should work , this is an old user manual I have I don't know how many panels are called concept but might be same

Get user manual?

Unset bit??? What you mean bit?

Maybe service timer Need engineer Better to scrap it

Viper they is just the cheaper version that tvt make but better than there other brands imo , I don't buy it from them myself but know that versions they sell , all made by TVT including the domes bullets associated with the viper , all tvt products

Qvis version dont use superliveplus? That's a tvt machine that qvis have started to supply called viper , unless your saying there explorer version has been modified to work on superliveplus Explorer is there new app , forgot what the old one was called which can no longer be downloaded even though electricians still sell what's left confuses them as box has old app on it

As James having full bars doesn't mean mean path established

Hi

WiFi problem? Assuming when you get the problem your internet is actually present

Unscrew it and scrap it

At what

Nah 4k7 Redredred? 2k2

D- to 0v D+ to 12v STB to STB Bell to bell Z33 to T Then leave resistor as you have it, you have a 4k7 there which needs to be also programmed in wiring selection choice menu

Also I think your white wire needs to go to z33 and z33 is programmable in menu as a bell tamper , z33 normally has the resistor on it in series so like white wire connects to resistor and then resistor goes into z33 , resistor mostly goes in bell , but your in bench DIY unit won't matter Been a while since I did this , isn't D- , zero volts so that's where the black would go ?

Why is resistor there? Just put a striaght link in

Can you send pictures how your wired it or drawing or aomething

So basically ee full of it and talking rubbish.....

Does it connect via the hik P2P on his phone?

How far you got then?

Sab box is no good for these small panels , on power cut, for any reason they can't give the hold off voltage required so you will get continuous bell rings etc

Do you have the wired module in the panel? The ag6 is no good for this panel as it doesn't have scb mode from what I remember , pack it send it back and get a texecom odyssey 1e or something like that After thought if you have a WiFi module installed can you still install the wired bell module? As I thought there was only a position for one board , or is the WiFi onboard the V10 main board? Someone else might answer that bit

I don't get it , as others have kind of mentioned , why did it get to a heavy hefty bill rather than the alarm company or arc not notifying of the failures and that something is wrong Or is this how it is , asking monthly parent is made coms failure is a side issue lol You means coms between arc and alarm company? As arc needs to inform alarm company , alarm company speaks to customer Sums it up

I don't know what it's called but I fixed a dialler issue this way as they wondered why it wasn't dialling out since fibre went in , the phone socket was the white fibre box and was already active

Bt Fibre to home , line voltage is local , seech diallers have no problem dialling....