So you need to know what ports your DVR uses , those ports need to be setup in the firewall section of your router by creating rules , then those rules would be applied and asked to be sent to your DVR IP address
You may need to set your DVR to a static IP setting if your router does not allow you to port forward via Mac addresses
Do you mean default codes do not respond ?
Or
Keypad in a whole does not respond no bleeps no lights nothing ? Or frozen like with lights on?
Has it been a year since you last tried using the alarm?
Probably something like wrong polarity or output connected to dialler , so when you disarm it is sending the trigger to the dialler
Assuming it's an external dialler and so on
If it's old system did you change settings somewhere ?
Or new and not sure how triggers and outputs work so wrong connection
If you mean the enforcer , it has an output board and it's labelled kind of different on how to use it and what you can do with it
Throws all the diyers into paying for bell part to be installed by engineer these parts
House bashers do, I never been a fan really , I think some of the grade one stuff works better
I sold those risco bits quick though , all diyers on eBay ,
I have three new panels to sell aswell , wisdom ones looks like they been sitting around but two are sealed
They make good money on eBay if you get it all free that is
Can't take you seriously now, has to be some blag in all this somewhere lol
Ah I had one other day , just about swapped a Pir to another zone lol
Why they make it so confusing or was gardtec risco and the wireless all botched together with a few firmware updates ( Mr texe will be reading firmware bit)