MrHappy

Deviant....

who's Ash Wood ? & why do you have his sockets....

they must get funding....

C or H, push up to unhook lid, rive down & the lid will either break free or hang down enough to unscrew

its older than you! cut a hole & pull the piezo's off

diamond blade, as it was in the machine 1mm would have cut squarer...

diamond

The soffits had been redone on one system so I could not get the lid off... I have now progessed to butchering with an angle grinder

I have been in the office, Went to power down a system Looked at a CCTV job Been back to the office Went & changed a Veritas R8 to a euro & replaced ewd Changed a 2nd veritas R8 to a euro & replaced ewd Changed the wiring on a p24 to eol & replaced the ewd Surveyed & verbally "won" a 4 cam domestic CCTV job. Went home, ate pizza Returned to work as the shutter was up. So it's 9:30ish & the days not really completed...

no, I've been busy protesting...

?

leaf it out...

TBH I like the attention...

staff are returning shortly, so I will have time to complete projects... the other issue is whenever you ring anyone their working from home, I feel a bit of twat when you can here there kids / mrs in the back ground & your getting them involved in work shite (even though there paid for it)

I need to get webway to set up the logic gate thing so need to call them in office hours, but have been out on the tools, If you need it back now I'll send it

Nope, there's sets of redundant optex beams on the roof & a pyronix belle... But unless I'm getting paid or need to remove it to fit my kit, the junk stays on the wall ?

Its one way due to Covid 19, the greengrocers was in working the little cafe too, I wanted the sweetie shop, but she was no there...

sooner or later you will discover cheap cider, and fulfil your full potential of spending days in the park shouting at pigeons...

resistor on the screw 1st & then wire appear to work better...

you want the same sized screw driver you'd use on connections inside a fused spur you don't need crimps or anything to terminate resistor or wires* into these PA's (*or iD biscuits) when put the conductor onto the alarms cable, are you cutting a bare bit of 15mm ish with bit of insulation on the end & giving it a twist ? if it was going in a pir you'd cut the end & shove it in.... if going around a screw you'd twist it around & cut the excess off when the screw is tight its pointless looking at the panel readings there only a guide, if its going to play up due to poor termination, place the system in day & firm the device with the handle of your screwdriver

@ttstick looking at the screw heads I'd assume your use the same screwdriver to terminate the button & the keypad ? If so I doubt the button or jb's connections will remain tight ? The texecom supplied resistor have really thing legs The cable & resistors are really short, do you terminate the cable conductor with a twist ?

I think you should have spent longer at school ?

Vandalism badge...

glitter... so like the early 90's ADE ?

I thought you was an ADE fanboy ?