Jump to content
Security Installer Community

Recommended Posts

I've just installed a new Vista 20P and I have programmed a motion detector as and Interior Follower, the front door as an Entry/Exit #1, and the motion won't trip the alarm. Both zones are in partition 1, and I'm arming in the Away mode. The motion shows up as a fault, on the keypad if it is activated prior to arming.

 

This is what the keypad shows for each of the two zones:

 

Door:

Zn   ZT   P   RC   HW:RT

03   01   1    10    EL:1

 

Motion:

Zn   ZT   P   RC   HW:RT

05   04    1   10    EL:1

 

I'm stumped on this and could really use some help.

 

Thanks,

Bill

Edited by nashville_bill

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.