al-yeti

Replace it with another model , to risky to touch risco

Dude easily solved remove the sounder wires Add a speaker to the speaker terminals and it will give you something similar for now

Buses do all ages , no lifting etc , they take all sorts down here

What particular bell and strobe are using ?

Yes it was a long shot I was thinking maybe internal siren on an output changed from something

Check how the internal sounder is wired ? What connections is it going to? I assume.leypad.jist shows model and date time with no errors? When unset and sounder activating

Yes that will work

What siren and strobe You could use an 8core , keep the power to Rio from the keypad power and the separate power for the strobe and siren

Open them ....

This happened on windows 10 aswell , you need to mess about with drivers and windows settings , I don't really know why it happened to me but flaffed around and got into work in the past So glad I don't have to use RSS anymore

Your engineer code is different from what your trying

Well seems seems the panel uses a common and then zone legs With the flex you can use two wires for power plus and minus , and then two wires for the zone What pirs are you using , perhaps a picture of those aswell will be helpful, Did you get a resistor pack with the flex 100? Those may or may not need to be installed in the pir

Manual would have been better to use Board is cheap and available

Enforcer will power the master blaster?

Weird how some bells will ring for days on there internal battery lol

I didn't think they were 12v cos they run in scb mode and stay lit when power removed from memory , maybe they are lower voltage from bell when 12v is gone from panel

80% of market ? Meaning manufacturers?

Either you did well as your message shows , so probably as he said well done and welcome Or You had a link , which was removed , but normally that shows saying link removed

Keep logging and reporting, not sure I would agree that councils have power to remove cameras though , because probably those that did , didn't pursue what powers they actually have and follow a course of action with them , most people want the problem to go away if that makes sense. Evidence is crucial , also look up the info on nusciance neighbours I seen people get also done by councils and courts although it takes a long time and patience to log and report log and report , eventually you will hopefully be on winning side Some people do deserve action against them

Detectors Add/del detectors Something like this?

Not sure if that is correct menu tho, what's the route you take there ,has to say more than just add....

I can't remember exactly but you need to delete the radio device right ? You sure your in correct menu?

Devices menu add/delete?

You sure nothing dropped out of it ? Have a look at the case how it closes the tamper? Or eBay seconds ?

As above just take it apart and switch it all off bit by bit , I would start with switching off mains , the disconnect battery, mean while your external bell and perhaps internal bell might being going lunatic stylee , hopefully you already have your ladders setup and ready to smash it to bits if it doesn't play ball Btw if old panel still works , leave it in place and set up your new system on the bench , set it up in how you want it to generally work and then install it after , unless your confident anyway , you can still rip out old one