al-yeti

If they are ssaib approved that is....

Plenty CCTV even the mobile phone operators getting in on the action Decent CCTV systems dying trade

Are you the engineer? Or you need to contact the engineer , thought you need them to connect to cloud? Is it because risco has started charging and you have been disconnected?

I think the hikvision bell with wired bell connection is good And if you have a bit more money then the comlit vista which has an onboard relay is good to But both versions are an electrician nightmare lol , but they seem to fit the Veritas ok lol Ring is just made for the diyers especially the WiFi version on battery pack , you unplug it charge it put it back , other version is two wires and your done

Yes , not familiar with flex 20 but don't they have a seperate zero volts aux power ?

Lol Stop selling the £25 hik and look at better models Although corridor model can be strange at times to look at

You have spare cable put the same sensor on a fly lead and experiment if you like

All great tips , but this one's hardcore good advice

As our yellow friend stated why all devices wired this way if your using eol So you have your answer

No b- isn't tamper return , look at list A wire that came back to bt was the tamper return possibly black if nothing was changed from your original picture

Also you should go for eol now rather than later otherwise you won't do it And get a ladder for the bellbox learn to balance with drill screwdriver and bellbox

So just to go from panel to panel if that makes sense Bt is tamp BA is trigger B+ is 12v STB is strobe B- is 0v I think lol

Ok so earlier you didn't mean to write bell+ It's bell then +12v So the terminal bell is the bell trigger

If you think the wiring and connections are fine , what happens if you move them to a working circuit as swap them over at panel or expander , the fault will move with the zone or it will be the panel output problem

I think you got it wrong somewhere , picture of panel connections please? Texe experts will turn soon the firmware suitcases

So the black bt if it's the bell trigger then it has to go to the bell output on the texe I don't the texe but would have thought it's obvious

Where's the bell trigger on the texe? I assume it's bt for bell trigger on the pyronix

Stalker

He's just a alarm enthusiast got nothing better to do

Everyone from our age, although I might be older I doubt they teach it much now

No common to have the two recieves The fobs are probably added as hardware then in the engineer menu so without that you won't be able to correct the issue , meaning you need the engineers code It's worthwhile paying someone local to sort out and check the whole system over, in this DIY world everything unfortunately into always DIY , not having a dig of course As someone mentioned in another post these risky risco you need product knowledge to sort problems out , i hate them personally and normally guess my way round fixing issues , so etimes with help from the local monkies

Or there may be an option ,under user options what the fob does for each user

Means you haven't programmed them or incorrectly, the reciever will flash when it recieves a signal but won't do anything because the panel hasn't been programmed for the fobs Example galaxy is the same the RF Rx will flash but do nothing if it equipment hasn't been added because it's seeing a tx Just a general comment Very few risco installers it seems here , either DIY or stuck in there ways lol

Fixed

So as above you can switch them in via menu but assume you will need an extra battery pack for it to last Last one I was called to, i wired a bell instead and stuck the wireless box in the outhouse instead