Jump to content
Security Installer Community

james.wilson

Admin
 View Profile  See their activity

  • Posts

    30,672

  • Joined

  • Last visited

  • Days Won

    288

 Content Type 

Everything posted by james.wilson

  1. james.wilson
    I wasn't meaning it to come across that way. I prefer to know about issues etc. If it's read that way then I apologise.
  2. james.wilson
    His test desk?
  3. james.wilson
    As above Optex detectors?
  4. james.wilson
    no I think its best you prioritise it. The membership here needs guidance and thinks your playing all for your own benefit? seen as you rarely frequent here till you have new info.
  5. james.wilson
    cg can you give a best practice tsi members should be doing? to mitigate the issues as much as possible
  6. james.wilson
    As above when was it last serviced?
  7. james.wilson
    you cant test mesh unless you test every device to location through the mesh. that takes a while from what ive read?
  8. james.wilson
    Sorry I wasn't meaning direct mic links. You meaning mic direct links, curvature of the earth?
  9. james.wilson
    Ask the questions, make your clients aware and upgrade as a minimum I'd say
  10. james.wilson
    Bear in mind WiFi is like old hubs. Be careful on bandwidth. I'd be cautious over 3 cams at low framerates
  11. james.wilson
    I'd advise covers but I do the same and take em off
  12. james.wilson
    if its an 'escape route' then yes
  13. james.wilson
    do they not look to you for advice on whats good equipment?
  14. james.wilson
    No it isn't programming. Out of the box it wouldn't do what ur reporting. Prove the panel by disconnecting everything then once proved add things one at a time. One option would be to wire the rear door onto 2 and link 3 and follow the same process if you don't want to strip all the wiring
  15. james.wilson
    agree with all of that.
  16. james.wilson
    check the resistance between the 2 circuit wires too
  17. james.wilson
    no it wouldn't (bellbox) on a walk test. But I do think it isn't a panel issue run a temp new cable to the 2 devices bet it doesn't continue I think its external
  18. james.wilson
    id say you have a cross voltage between the 2 circuits.
  19. james.wilson
    It has to be wiring if it was panel we would get loads of returns which we don't the optima has a very low return rate and then its usually because its been wired wrong and blown
  20. james.wilson
    Ah did you remove the wiring from 3 when you linked it out?
  21. james.wilson
    I'm wondering if your overloading it?
  22. james.wilson
    What happens if you remove the bell
  23. james.wilson
    how do you report fault (ie tel line digi etc) to the fire panel? Is the intruder alarm compliant to bs5839, whats the standby time of the alarm (as the dialler will be powered from it if wiring direct) etc etc etc
  24. james.wilson
    If you have provided a 5839 cert then wiring it non 5839 kit would make the cert invalid.
  25. james.wilson
    you have to have them as an approved firm
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept