al-yeti

Just mount the box in a more suitable position , you just have to deal with any other repairs , that's the way it is

Ok that did make me laugh Think we bought this from supplier, upgraded to Honeywell , and put it in a garage , Honeywell really are rubbish in comparison to hkc , texe , scan wireless systems

6/14? I have one on mates garage rear of his house works well for it's use

You need supervision

Good alarm for sheds

How much you pay? Basic ddns £25 for a year? For a few addresses noip

Many paying bit more and going for nest Most around here basic hikvision 4cams £900

According to the gov site a non backlit sign with details of your company requires permission All vague in my opinion

According to you then all your bells are blank? It doesn't have to be illuminated to be considered as advertising

Get any sign writer to make it for you and press it on ( not stickers)

Yes dead battery killed proper , you need new bell to start with

So sounder was £30? Didn't realise you paid so much thinking it was speaker Apologies , yes hope you kept packaging return won't cost you more than a fiver and probably cost you £17 .50 in end for speak not to bad in the end

Yes but your going in circles now read all answers more or less what they been saying all along

You can disconnect the tamper aswell and use that on a tamper circuit Either way you can't use that circuit board on the speaker output simple

In new one disconnect the speaker from the circuit board and use it as you did your old Or swap the case damaging the tamper switch won't matter Or use this new one as an internal bell and use it on outputs and keep broken one connected as is Just swap the case as said above

Yes pay dialler DIY dialling It's DIY or installer with arc

You can dualpath DIY Just buy a dialler and a GSM SMS unit and stick them both on , some will even poll for you , with enough inputs you can even get the GSM unit to message on line fail Other than getting an installer and monthly contract you might as well forget about the arc

What you talking about dude?

So zone 9 has an expander on it Sounds like an abacus split lol only 8wireles zones connected to one zone input ? Where that bloke DIY swb when we need him........

I fixed one recently an elite , similar system , has an external bell was installed by a builder not bad lol, freaked me out why it wouldn't set The builder clever one put the garden door sensor into the frame on a bifold after years slamming the door damaged the reed , I thought that was it but theres a gap behind the magnet side and the magnet itself and popped out from behind into the frame so not allowing alarm to set and always showing active Standard flush round magnet mounted on pillars into door , groove in door is where magnet was

What has engineer said on three visits ? Has it always said same fault ? Could be a fault on the cable How do you know nothing is connected to zone10? Can we see a picture of what you mean by "according to my installation instructions" ?

Panel probably needs to die to Did you check the forum listing for installers in your area , sure someone will be happy to quote for replacement https://www.thesecurityinstaller.co.uk/community/forum/268-uk-security-installers-by-regional-police-force/

Your better off just swapping to an ion40

It's probably the main battery aswell Get alarm looked at if alarm is important to you and them by an engineer

I never rated the sd1 etc allot of failures out there