al-yeti

No man those oval things with cable premade

So doesn't have to go into engineer mode to send new engineer code?

Hate those Honeywell g3

You in Spain?

That's what subbies do to get paid for first fix

Silent on panic setting?

Why does Logan's name say guest?

Commissioning? Like second fix? Lash panel to wall Keypad Bellbox Detectors Programming Testing All via lazy laptop where possible Demo for customer , and go get some grub if they didn't give you any .....

Well there's loads of old parts marked adt on eBay so as long as your security is just a DIY thing ,and not protecting much of value to you , should be all good

If wiring correct There's a screw near tamper switch , or you saw it in packet and didn't put it in , that will help push switch if surface behind wasn't even You don't need to remove bell , just put screw in and turn it to adjust switch slightly and you will here the switch close quicker when cover is pressed down Assuming it's this , but it is normally the problem

Grade 2 easier to do than grade 3

Strangest comment so far .... But keep going

This bit most serious comment you have written and explains the job, so in this note carry on Good luck to someone who takes it over lol

Veritas will be difficult even the electrician's can't do them fully Start with Honeywell g4 - 9651 - galaxy g2-12 - then dive into a dimension on left hand and premier elite in right at same time

I do a bit , hate the bell boxes high up never understood why they do that , bunch of nuttas and muppets

Nah, this means you can probably fault find , so qualified.....

If you don't use it, a d don't think you need security , switch it all off end of story I assume you didn't have it installed and was already there , cats or no cats alarms can work with pets if make adjustments All depends on how much you want to spend on it and wether you think yourselves or anything in the house worth having some kind of protection

Hardcore What was it then? Ion40 ?

On a side the galaxy dimension panel wasn't made for the diyer Lack of information is more about lack of knowledge, training and experience So other panels you will find same situation where you don't know what it can and can't do

Would accept both

Ok dude I remember the external coms devices and cards

The versions are upgraded for development and sometimes correcting earlier glitches Version 7 example was superseded within week I think and so on Firmware easy to do , just buy it on a stick or if you can get the files there are other ways

That's what I thought C for confused dot come in my case lol They both have Comms on board tho

What about the C and the D?