_2d2230.png)
_5a42ce.png)
al-yeti
Trade Full Member
-
Joined
-
Last visited
Everything posted by al-yeti
-
In that case leave it as is until your ready to change it or get someone in
-
How manufacturers apart from risco and honeywell make a touch panel?
-
Although I think you will get stuck programming it , as above you can read it manual , mean time run a cable to every sensor point to get started and bellbox location Com2400 leave it for now will just give you more headache I believe
-
Are you doing all of this just because the display is flickering or other reason?
-
Alarm / cctv monkeys? Maybe he means to some kind of standard? Of course hb1671 says it's ok
-
Yes Loads docs online
-
Are all the devices two way?
-
Power master two way?
-
Looking at your pic Red / brown maybe positive + Blue / black maybe negative - Just power them seperate On adaptors centre pin is normally + and outer is -
-
-
-
Unless everything moves over to bus system including detectors then you will have to replace everything
-
-
Get a basic kit but £350 won't get you far Texecom ricochet Pyronix enforcer Visonic powermax All diy available, and friendly I think, More budget get an installer to fit the above or a HKC Get some rebate on the holiday only go for two weeks instead and get good security
-
This one better , but as DD says forget the internal door and put that sensor on another window somewhere Any flats roofs accessible near windows ?
-
Time for you to read up on the manufacturers websites perhaps do a comparison
-
Wireless sensor for example fixed to doors and windows activate in vibration Simply put if Mr H comes round with a sledge and wacks your window , providing you setup the detector correctly it should activate the alarm Shock sensor / vibration sensor
-
Maybe I just find it weird, but then so am i
-
Just put anti snap locks in and shocks on the doors and windows But your budget needs to be bigger
-
I'd say long run texecom will give you more head ache as a diyer , the deeper you go, visonic menu is messed up but does a job , enforcer might still be slightly ahead for setting up Visonic for diy then
-
Try the enforcer , I don't install it but I hear it's a great diy panel also installed by professionals .…..
-
OK look how to set it up and what the pot does adjusts microwave
-
You still need to setup it's range , little grey pot top left , where is the sensor being located in kitchen? Did you get instructions with it?
-
What's using got to do with it? As it says where guarding is permanent? Then licence required, I don't know allot about mind you
-
How did you ascertain by simply taking it off test its fine? Maybe it's intermittent