MrHappy

offered this today.... naff ain't it.

Get in touch with Risco & they will provide you details of somebody who will be able to support it. However, non maintained alarms that have been tinkered with are as desirable as chlamydia....

Cool, you should be starting to get good at it by now ?

Zamunda ?

I was chatting away to client on how he even up as a diver (long retired) the judge gave him the choice of borstal or an indenture on a trawler aged 14 he'd purchased a gun to kill his dad but could not get hold of the bullets...

I assume your self employed ? Ask silly money for new installs.... or go & a drive a van for Asda or whatever ?

why 45° ?

Do you like cigars & chunky jewellery ?

appear to have failed. ?

ali tube is 12.7mm aka 1/2 inch you need a 1/2 inch spring, however it don't bend very well as it right cheap & nasty shite compared to what it used to be.... So I doubt your going get 45° 1st result in google - https://www.ac-one.co.uk/tube-bending-springs-1281-p.asp Post a picture of what your doing we can take the piss ?

put resistors in your old tat & get the system working before you buy some new tat ? anything with a n/c alarm + n/c tamper will work with your galaxy I have no idea what pir's are sold in the Australia market, however the panel can define its own resistor values MSpaint is cooler...

single EOL just power it off the panel ?

Sadly most of the weird & wonderful stuff is gone. Most things are off the shelf stuff by the cheapest provider.

between output & 12v ?

Fitted correctly they are bullet proof. If you wish to default use setting - "CLEAN START" from the engineering menu However, lets start with the very basics ? Loosen the 2 screen under the panels back plate so you can hang the front panel underneath. Is the ribbon from l/O pcd fitted correctly? Have you +12v & com on DC voltage with multi meter ? Remove the trigger for MB or EWD & touch it to com your device should sound? Yes = programming issue(s) No= fuse of wiring issues

You get what you pay for....

They normally sell stuff rather than have any idea to fit stuff The common is a - for all stuff on the pc

there's ya problem.... I'd assume the fuse on the I/O is unmonitored ? you checked it ??

Looking at all the brown shoes....... unlike London your streets ain't paved with gold ??

Yale ?

Pos applied for EWD is ring not what I'd expect, but I never worked for chubb... Is the stobe output programmable ? (eg someone could have it programmed as set or similar ? )

I've a cheery thought for you..... The bloke that fitted 'em will probably be dead ?

reset & adjust the tamper ?

Probably plastics where made in different place to electronics ?? I've seen clone Honeywell's DT's before.... https://www.amazon.co.uk/Bedler-Dual-tech-Infrared-Microwave-Detector/dp/B08GFKVHN2

OP, Yours is 6 wire sensor with no tamper circuit The real Comet- In some of the Alibaba pics the "clone" has "Rokonet" moulded onto the cae