norman

As above, the norm would be to make sure the cables meter out, there's nothing obvious maybe lift a couple of carpets near the door jambs to check for damaged, poorly run cables. Once you are happy, make the customer aware they are paying a lot less by you utilising existing cabling and document it and the fact it's not covered under any warranty, on your spec refer to each device as 'utilising existing cabling' too, this is the norm in this type of scenario.

Amen

You'd be better installing something that's not tat or likely to cause you revisits and generates recurring revenue. Customers have no idea what they want.

Dave Bartram?

Meh!

Hi Colonel, I love your chicken.

Selfish bstards!

As I sad above, you have absolutely nothing to lose by defaulting your current panel, if it works yay, if not then boo. Oh, and Texecom won't give a shite about your experience with an approved installer, I expect the approved list reads like a who's who of DIY alarms.

You may find crashing and reprogramming the current panel cures your issues, as above I'd bet one of the bells is a dummy.

Yes

" reseted to factory setting " Sheesh!

My Mrs has a nurses uniform, doesn't make her a nurse...

So not a Secom guy then...

Nutter. Hello btw.

Lots, if not all at fault companies will jump in as quick as they can, this is to control the cost.

Anything used in line with the job, i.e. laptop, phone etc are a bit naff mentioned in the advert imo, it's as though they should be thankful you don't make them get the bus.

My Mrs has a couple of things.

Oxymoron?

Obviously an avid reader..

Can't remember tbf, you're probably right.

Capable even...

IC5

I had one many moons ago.. They don't make clusters like that anymore, as a young kid it felt like I was in control of the space shuttle.