Shaunb1905

Just stick some grade F, Aicos in. About £50 each. Job done

They will never be able to police this. Will only come about when you try sell your house surely?

Remember a few years ago, customer called us out because their alarms bleeping. Was someone’s hair straighteners, which were left switched on!!

Is it not zone 200? Output group 199?

Easy enough to do through programming

It’s seems daft to me when you think that the cables in the panel like the zone, loops, sounder circuits etc are close to the mains cable and connections

Travel distance doesn't seem to be more then 45m or reduced to 25 for special hazards?

As above A lot of the time I find L3s can be very similar to L1 depending on the layout so I just go L1 anyways

What’s the issues?

Is that what they charged him or he’s trying to charge you? Have you counted the devices or have you seen the certs? Only asking because if, like you say you have a suspended ceiling, they may have installed detection or even a smoke beam above?

Morning chaps. Does anyone have any idea where to get one of these from? Thank, Shaun

Are they integrated or ancillary base sounders?

Hello, A Dell for me See what I did there?

I meant PSU sorry

I'm sure they're is a conventional sounder capable, so just stick a sounder controller on the loop (psi needed) and good to go

Usually they try pass it on to their Electrician to try and do

We've got generic ones that gets changed to suit the job.

Sounds like there is more to it, too me

Protec's are known for **** power supply's!

Change it for adressable and put multi sensors in and set up cause and effect, day and night mode?

Lots of issues with twinflex! Agree about alarmsense, great bit of kit

Must be mental using twinflex!!

Fun size Mars bar??

New connects are very very good!

Dewalt ones, screwfix do them for about 30 quid