Evening all,

 

I've gone to go out and arm my texecom system today, however when pressing 'area' to quick arm, the keypad produces a long beep and says 'keypad locked!' I have tried pressing yes and no down together to unlock the keypad, but it doesn't seem to work. Wintex works fine though. Will it be a case of power cycling the panel or am I overlooking something?

 

 

 

Keypad lock is built in to the keypad AFAIK.

Maybe a button is stuck stopping you from unlocking it?

Press Yes & No,. Not Yes & Down

Yes and No is the way to go

Edited June 9, 20169 yr by secureiam

Did I miss something?

The OP said Yes and No.

1 hour ago, sixwheeledbeast said:

Did I miss something?

The OP said Yes and No.

 

Doesnt always work correctly by pressing at the exact same time, I always demonstrate to customers by keeping YES pressed in, before pressing NO

 

1 hour ago, PSE said:

 

Doesnt always work correctly by pressing at the exact same time, I always demonstrate to customers by keeping YES pressed in, before pressing NO

 

 

the early ones work, later ones need your trick

Or a brick

I was quite close to using a brick to unlock it! But thanks PSE, the trick worked!

always done yes and no, rather than at the same time hold down yes and no.

 

only other lock is a code lock which should reset its self after x hours, but don't get many of them.

 

 

Brick is always useful in your tool kit....lol

 

Edited June 10, 20169 yr by secureiam