Jump to content
Security Installer Community

enasecurity

Member
  • Posts

    31
  • Joined

  • Last visited

Location

  • Location
    milton keynes

enasecurity's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I was quite close to using a brick to unlock it! But thanks PSE, the trick worked!
  2. Evening all, I've gone to go out and arm my texecom system today, however when pressing 'area' to quick arm, the keypad produces a long beep and says 'keypad locked!' I have tried pressing yes and no down together to unlock the keypad, but it doesn't seem to work. Wintex works fine though. Will it be a case of power cycling the panel or am I overlooking something?
  3. https://www.surveillance-video.com/security-sic-0400-n.html/ looks like Samsung also do wired systems now too, en50131 compliant as well
  4. Was autoset turned on? Under autoset go to status (option 1) I think, and turn it on
  5. The groups will be whatever zones you've assigned to them, you don't have to have groups enabled for the system to set.
  6. Directly into sub menu 3 autoset (menu 65, option 3?)
  7. Expander is much closer than dialler. Would I still be able to have zone text and check the zone status through wintex if the zone wasn't programmed in?
  8. Hi, I'd like to connect the relay output from a fire panel into a zone on a texecom expander so I can monitor its state through a dialler. However, I don't want to have to reset the panel everytime the fire alarm is activated. Is there a zone type or attribute I can use that will only activate an output programmed as mimic and automatically reset when the fire alarms output is closed? Thanks
  9. I have no chime zones setup. I have rebooted the panel again and it seems to have sorted it. Texecom mentioned going into udl/Digi options and pressing yes 20 times. Does this do a soft Restart? Thanks again I have no chime zones setup. I have rebooted the panel again and it seems to have sorted it. Texecom mentioned going into udl/Digi options and pressing yes 20 times. Does this do a soft Restart? Thanks again
  10. Hi James. The system has no smoke detection connected to it. Are there any settings in wintex that I should look out for?
  11. Evening all, I have a premier 88 that was purchased new but only installed 6 months ago in replacement of my old menvier panel. It has been working flawlessly since today... It seems like one of the zones is stuck in walk test mode. When the zone is opened the keypad and internal speaker produce the walk test/fault tone. I have been on the phone with texecom and tried unprogramming the zone, entering and exiting walk test, powering down the panel....everything! And it still seems to be stuck. The system still operates fine though. Has anyone else come across this problem? It seems very strange! Thanks
  12. What software version would be best once I've changed the chips to a single 256?
  13. Would the 24LC256 need programming before being fitted onto the PCB?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.