james.wilson

if you run it only on the battery does the comms issues stop? if yes psu issue if no not psu issue its definetly not normal

Not sure on your panel psu size but if you ditch all the spks then what do you get. I haven't looked in detail but what's the day current?

Hi 1. That isnt normal 2. If everyone serviced systems this wouldnt be required however it is a good idea but i understand your concerns but isnt an issue for a healty system your 16 ohms, they all on one or 1 per expander? how are they powered? if panel powered have you doubled or trebled up the power?

Sorry don't use the stuff. Is it part set or groups. Code and keypad permitted to arm b?

according to the diagrom provided above its single resistor non eol so

As above you need to disable the sab, self actuating bell in the bell. As H if its not pro gear or not installed properly then it probably won't work as it should

Agreed use a relay to give you a clean switch

We've launched a new panel - the EURO 76 ? James adds i thought it already existed. Was the euro 44 then the 76 then the 134 announced before my kids were born? i wait to be corrected.

good news how bad were the ones you had? or was it range etc? ie what did you have before and what do you have now

ill keep doing my best.. to break ta

I should of added a Mr happy ?

Hopefully nobody noticed but there have been a few upgrades on tsi. Mainly aiming for speed improvement on mobile mainly if anyone has seen a speed increase.

Be interesting to know a little more about it. Maybe an actual reason to got to the nec

i think we will have to agree to disagree Al

i wouldnt want to send anything over IP without encryption. Al it your password 1234 or P4ssw0rd?

Ive yet to meet anyone that didnt like redcare classic/gsm.

if you have an additional 2 circuits where the 6 core goes back to (im assuming panel) then just use a pair for each contact (ie red/blk contact 1, blu/yell contact2 etc) and program the panel to the correct eol values. Wiring should be in the manual but if not just say and ill dig out an image. But also bear in mind how the contacts are installed. If there is an issue there however you wire them you will have problems. Post a picture of the 3 with the door closed please

encryption prevents data being in sent in plain so it cant be read or intercepted. If sent in plain you could send the an open or an abort signal etc without it actually coming from the spt

everything should be encrypted especially in security unless i missed the sarcasm?

Also if its just std surfac door contacts how close / inline are they? Are they decent ones? maybe a picture of how they are fitted. As 6 says as you can now see fault finding is needed as all you know is its one of the 3 rather than identifying 1 contact. However if its stable with 2 and unstable with 3 id suggest its local to the 3rd. I presume as 6 its double pole and you havnt hidden resistors somewhere

Is it a 6 core cable? If so just use eol contacts \resistors and put 1 on each circuit. Id only put 2 on 1 circuit if its double doors

Anyone know of it/them Signal Dynamic - News - Signal Dynamic Launches Redcare Replacement

agreed something with poe passthrough

Pretty much any hybrid or wired panel will do that. Assuming the peripherals are ok and of decent quality

the IT industry is used to end of life devices. we have been reporting kit as eol for a while now. But noone upgrades security devices. Had an adpro fail today that was reported as eol years ago. but if it say a switch is eol it get replaced immediately even though its the same network etc anyway link to article Over 92,000 exposed D-Link NAS devices have a backdoor account (bleepingcomputer.com)