See attached

en50131_bs8243_pd6662.pdf

nope

it is now

It is quit helpful.

Gents

Very useful file and just what i was after. Just a couple of questions. Is the seperate tamper signal needed for both g2 & g3 installations?

Also am i right in saying you only need a single line path fault on a g2 and a single and full line fault on a g3?

Yes on the first, don't understand ur second?

Ah, this was the thread I was looking for a few weeks ago.

--

Path fault signals don't need pins if that's what you mean.

Edited November 12, 201411 yr by sixwheeledbeast

I wrote that booklet and I think it helped a lot of people understand the basics of the new standards. I think help guides like this are essential when busy installers are faced with new standards. I was not happy when the marketing department put a picture of me in it  

 

yes, tamper must have it's own channel if using pins for fast format. 

 

The question about path faults is not clear. What are you asking?

I actually thought it was quite good, nice effort.

I actually thought it was quite good, nice effort.

Thanks. Blush.