9651
-
Posts
2,477 -
Joined
-
Last visited
-
Days Won
5
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Everything posted by 9651
-
Correct
-
Must be to do with the mesh then, as a galaxy will just report the device as an rf fail when flat
-
Question so when these ricochet devices go flat, why are they jamming? I believe that was my issue and I see it mentioned above a simple point tamper would suffice!
-
I've just had to UDL our "problem site" again. Its been fine for 6 months.... but just taken a call of Alerts displaying. Radio jam is present and wont clear - every sensor jammed out.. Had a couple of low batteries over the last few days according to log, so presume a faulty device jamming the rest. 50+ ricochet zones. Brilliant. Wireless toss.
-
Genie is OK but personally don't like the user interface, bit quirky and looks old fashioned/cheap. Also the same with the cms picture quality of the IP stuff is fine mind, juts seemed to get lots of failures on the gunmetal domes for some reason
-
Id re start it (if you dare) i had had one that kept showing set with General fault, but with no faults present for around 12 months. Power cycle sorted it, but that's if it doesn't crash/not start back up first......
-
Too busy really.........just recently, stupidly so based north west not a bad thing I suppose, but plenty of 12 hr days and what not....
-
We are about to use dahua for all our IP stuff now. We did use genie, but it's too limited for what we need and we have had quite a few faulty cameras..... Currently have a 64 channel on the bench and impressed, twin LAN, twin hdmi etc. Also like the cms software. Jut need to try it monitored but I'm sure it will be fine
-
Is there no alarm on site to mimic cct/ links etc??
-
ebay tsnetlcd (well depends how old the TS is, is the panel grey or white?) or to change the lot replace it with a Texecom Premier 24/48. Closest panel you'll get in terms of connections/setup etc
-
replacement panel or just keypad?
-
stuff to just work? Ie no glitches between 3rd party devices.
-
Panel?
-
We don't clean ours, however on install I always used to rip any old ones down
-
yup (ive attached the full bulletin if thats ok?) SPECIAL BULLETIN No21 full.pdf
-
here we go, 4.5 f SPECIAL BULLETIN No21.pdf
-
cant see no mention in the notes i have other than the above.
-
only as i have my quick guide to hand BS 8243:2010 "Duress codes should only be used where risk makes it necessary and as permitted by the relevant response authority"
-
AFAIK, this is still the case, ie force still has to agree to a Duress
-
Can't say I've got it to work (not looked into it too deeply) you can get a explorer extension for chrome that I've had sucsess on genie machines
-
Welcome Where you based?
-
Do the plugins work?
-
bit like one of these?
-
How strange this was bumped I've had another request for some coverts today I'm going to spec ahd for the rest and maybe just use some analogue coverts. The genie machine we use is hybrid so will take ahd analogue and 1 IP It's not ideal but I can't find any HD coverts cams (
-
Lid tamper...... Front/back or both
