al-yeti

Is that 7k posts blag then you just added extra , as you don't talk much

No point making a new thread for similar question lol Thanks for input

Anything new on this front dudes? Quads Vs dt

Was all weird setup lol

Put chime in door contact Close door Give contact a light tap to see if it chimes

So I assume you mean you want to take over the monitoring And you will also need the engineer code from the maintainer

Those panic buttons look nicely used lol, someone after you lol

So garage has no detector? Maybe sensor playing up, when did you have system service last? Requires some investigation really , seems your circuit is split , but if it's a tamper fault of some kind , while set can show as alarm from what I rember on those

You got dialler on redcare? Leccy must be JB CCTV looks like a 2k job up north

Lol ok I thought moleys would be harder But yeah short piece , especially you pinch end a bit to make it a nice fit

Lock Smith's carry a tool slides over cylinder end tilt up and down fees seconds your done I didn't have patience to watch video lol if that's what he did

Common , no one cares though , they keep putting the standard cylinders everywhere

One of your Refurbs?

Police say don't lock internal doors as they cause allot of damage Personally nice loud internal bell , no open plan layout and lock them doors to slow them down , hopefully they just raid the fridge

Funny that, customers won't even pay for a new cover to make it atleast up-to-date , but they do worry about those knight rider lights

Or disconnect the mains and battery in one hit , see if the bell dies after a minute , otherwise put power back and do above as they said

Yello

Of course if you get threatened it's lashed in at half the price

120 a day he gets it lashed in time for tea

Chimney breast no big deal , you don't have perimeter protection so intruder would access room either way and trigger it once in I would move it first personally

Read more: Swap the quads positions with the dt see if problems follow the quad , although as above need to see or have systems described more Must be reason you opted for duals in other rooms, perhaps list rooms with sensors and why you chose what to go where

Did you setup individual users on DVR?

So you need to know what ports your DVR uses , those ports need to be setup in the firewall section of your router by creating rules , then those rules would be applied and asked to be sent to your DVR IP address You may need to set your DVR to a static IP setting if your router does not allow you to port forward via Mac addresses

Damaged data line , has to replace.cable at some point

I am near Heathrow , house bashing for a living unlike these alarm monkies sitting behind a desk