_2d2230.png)
_5a42ce.png)
al-yeti
Trade Full Member
-
Joined
-
Last visited
Everything posted by al-yeti
-
The advent dialler will trigger if on power up of the panel it's output switches , although lol the panels I have used it on never have done this with the advent dialler I think your confusing the two issues by talking about the dialler being triggered and the power fault As I don't get why swb responded about dialler as opposed to the power issue
-
Can do , and a discharged battery can cause the watchdog
-
-
At moment depends on your budget , which I thought you can't do , so after a few u turns I suggest you make your mind up what to do , not having a dig dude, just you changing your mind every post
-
-
-
-
-
-
Never had a problem with pyronix, apart from a grade 3 module , which one of you had to tell me why it didn't work , all real alarm man stuff , that's y TSI needs you So they know how to disconnect the tampers?
-
Unlikely op had engineer code , just wants to know how to unlock from start
-
600 kit to expensive?
-
-
-
Definitely wasn't mocking you And doesn't change your budget is busted
-
Nah, even Yale is going to bust your budget Based on what your saying now I think your making it all up, no one in there right mind would go from wired to wireless unless you had to Like I said , budget is busted , although some Chinese gear from.ebay might do you
-
Buy the 600 and get on with it where you get stuck just ask here Although I don't know anything about the 600 lol If your system is all wired then probably even the honeywell flex will be a better option The wiring won't be an issue as you can work out what is what before swapping over
-
G2-20 would do
-
No, detectors on some panels must be eol But any panel could be made to work
-
You also need to set bell in SCB mode And one of these I think swb means https://www.securitywarehouse.co.uk/catalog/intruder-alarm-c-36/wireless-ia-c-36_60/visonic-powermax-complete-powermaster-30-expander-module And I assume the bell tamper is programmed via one of the wired zones and you can use the pgm output You may already have this card installed so check , it's a bit tricky if you don't know what your doing You may need to hire a "real" alarman or local alarm house basher will do it cheaper perhaps just as good
-
You also need to set bell in SCB mode
-
Have you looked at the visonic manual yet?
-
Actually you mean something else , that's not a switch below it , that something standard in many devices , it's connected to the transformer , and has a fuse on it
-
Forget this alarm Perhaps a pyronix enforcer will work for you with remote keypad What you mean your technical in nature? Transformer provides power from the mains supply, and the switch you mean with a spring on it? Is a case tamper switch
-
Over the enforcer
