MrHappy

You was moaning your scantronic didn't silence & reset off the r/r input on the stu footprint ? Its old tat, if you wish to diy support it then its your choice, Your GSM things looks look "chinky ebay special", this one they claim is "grade 2" https://www.controlfreqgsm.com/collections/2g-and-3g-gsm-alarm-auto-diallers/products/gsm-alarm-auto-dialler-compatible-with-all-alarm-systems-and-sensors#.WOihC7g6BrM I'd suspect its not

Does this chap turn up for free ?

it either been skinned to lay flatter or the outer insulation has been damaged then removed ? who knows, subscriber might have complained about a bump in the carpet & this was the solution ? Its appear to have been in place sometime...

when the alarm was done in 80's it was very unusual to gut & completely redo a house in one hit. the cable skinned across the door way would be so it wouldn't be seen under a thinning carpet, the soldiered joints where quite nicely done its probably given decades of service... If you've the budget to have all the boards up & replace all the doors, why haven't you got £150 for decent controls ?

Being a simple alarm monkey, there's a no. of different BT hub's I had recent one where it took 2hrs off f#cking around as the menu's where despite have the port forward set up I needed to redo the setting a 2nd time hidden deep in advanced menu, I hate them almost as thompson / techincolour routers

rkp is the same plastics as the informa speed dialer, the adecmo I'm think of would be 4140/4170 & this sort of thing ?

Metal work was also used for the karimza, Its a piece of sh#t, I'd rip it out & put a euro mini in

ADE something in metal box.... edit- Accenta ABI ?

dunno, but its one of these-

The sensor is cira 25yrs old

aye

White A5 says RF Blah of something on it, I'll find it & PM a pic

no good deed goes unpunished...

Not made as progress since Jan/ Feb ? There is also a manual for the radio expander, i have a paper one & doubt you'll find a PDF one. If you where local to me for around £100 we could probably program it all back on. If you can't find anyone local to you, I guess your going to have to replace the system?

You fitting something you don't sell ?

Rochdale, known as the silicone valley ditch of the alarm industry ?

tried reading it in a brummie accent....but no. So I google'd it & came back very nerdy

welcome to TSI,

Used a Risco or wireless Texecom panel ?

euro mini enforcer

You sure its not Scantronic 9800 ?

Devices are marked with ICCID Sim No. Data No. Chip No. You'll need 1 or more of these bit of information to port it out, former ARC or former Installer may be really helpful & provide you with this information. I'd normally replace the signalling device,

there this amazing invention called a multi meter..... you could measure the circuits to see it there wired correctly ? or with the panel comes a poly bag, remove all wiring from terminal, place 2k2 resistor across each zone, link out bell tamper & any aux tamper, with battery fitted & lid on you should be fault when leaving engineering if so put one zone back on at time & check circuit with meter or built in check until every zone is in place do you have all 6 wire in the device ?

Some hero's don't wear cape's