Best way to disable and remove an old alarm system?

[mrala]

Yes, it is an LED one.

Also I assume by high voltage you mean mains 220V A/C?

The only cable going to the SABB is small bell wire size.

Research did say that some very old SABB units did have a mains supply.

Mrala

[sixwheeledbeast]

Xenon strobes have ~3Kv driver circuit. 

230Vac (mains voltages) while dangerous is considered LV (low voltage) in the grand scheme of things.

[al-yeti]

3 hours ago, mrala said:

Yes, it is an LED one.

Also I assume by high voltage you mean mains 220V A/C?

The only cable going to the SABB is small bell wire size.

Research did say that some very old SABB units did have a mains supply.

Mrala

Pictures would help if you can post them 

[mrala]

This is the unit in question.

Mrala

[al-yeti]

16 minutes ago, mrala said:

This is the unit in question.

Mrala

Might ring a while that as possibly not that old , you got procedure tho 

[james.wilson]

Of it's a hkc bell it is led. No risk of high voltage from the strobe. The piezo will be though. 

I'm seeing a trend of people wanting to remove proper stuff and asking how it can be disabled. Never see the same questions on simplisafe and ring etc. That's because they can be easily disabled. If you want a burglar alarm that can be easily disabled just get a doorbell and hope it's pressed.