Replacing Bell Box on Honeywell Galaxy 2

[Whiteside46]

20 minutes ago, james.wilson said:

If your getting 12v on your meter between bell trig and 0v the panel isn't driving the bell. 

Touching the bell trig to 0v in the panel proves this. 

Yeah that’s right. The old bell box must have been driven differently? 
 

[Whiteside46]

Solved it. When I started this post, I was looking at a way of disabling the current bell so I could remove the lid without it going off. 
 

I must’ve forgotten I’d been into the Engineer > Outputs > 1003 and switched it to not used instead of Bell. Switched it back and tested ok. 
 

should have done it all on one day. Stupid me. 
 

thanks for all your suggestions anyway guys. Have a good weekend. 

[al-yeti]

2 hours ago, al-yeti said:

So then if panel isn't faulty you may have changed the polarity by mistake 

 

Make sure it's neg and do a panel restart before testing it again

And of course as above did you change bell delay ....

So much the same changing polarity changing output type and so on all in programming

 

Well done for remembering

[sixwheeledbeast]

Congrats on completing your 15 minute job.

As I said originally there is no way to disable the bell, you have to get on with it.

[MrHappy]

2 hours ago, sixwheeledbeast said:

Congrats on completing your 15 minute job.

 

come on, I allow 30mins to do an EWD

[sixwheeledbeast]

15 minutes of tea drinking and paperwork?

[MrHappy]

47 minutes ago, sixwheeledbeast said:

15 minutes of tea drinking and paperwork?

 

8:30 to 11:00 to change a 9651 to a p48 inc moving spur, with ewd + decoy

 

1hr for panel 30 mins each for ewd, decoy & rkp

 

 There's probably a further day to add other expanders & circuits & cat 5 for comms

[al-yeti]

56 minutes ago, MrHappy said:

 

8:30 to 11:00 to change a 9651 to a p48 inc moving spur, with ewd + decoy

 

1hr for panel 30 mins each for ewd, decoy & rkp

 

 There's probably a further day to add other expanders & circuits & cat 5 for comms

1hr travel each way?

Setup

Analyze

Get pallets of doom in order

 

 

4hour? £150?

[MrHappy]

46 minutes ago, al-yeti said:

Get pallets of doom in order

 

you legend...