Scantronic 9651 alarms even when on installer mode, keypad does not show any faults or fault code, on log menu no fault activity shows, all voltages and tampers working ok, is this apanel fault? 

After reset and on user mode alarms. but again no fault code on keypad, again log does not show any faults.

27 minutes ago, Amit said:

Scantronic 9651 alarms even when on installer mode,

 

Outside box ringing ?

 

or something different ?

4 minutes ago, MrHappy said:

 

Outside box ringing ?

 

or something different ?

yes bell box rings so does internal bell

external  bell plus internal bell rings but no display on keypad and no log information

default & reprogram,

 

if it does it again , replace controls after check the cables....

 

is this just a system just a single EWD, 1 keypad, 1 speaker & a handfull of pir ? 

id assume the internal bell is connected to the external and isnt a speaker. Id go with a tamper on one of them but would need to see pics of how its wired

1 hour ago, Amit said:

 is this apanel fault?

Could be bell/panel or wire between. depends how it's all wired.

If external tamper was linked and bell duff could feedback to internal with no log events, for exmaple.

3 hours ago, sixwheeledbeast said:

Could be bell/panel or wire between. depends how it's all wired.

If external tamper was linked and bell duff could feedback to internal with no log events, for exmaple.

External bell tamper not Linked.

internal bell is a speaker, i have checked the wires to external bell with a meter and all 5 cores tested ok.

Yes I do suspect external bell but passes bell and strobe test.

 

Z1 =Front door contact.

Z2 = Hallway Pir

Z3 = Reception Pir

Z4= Dinning Pir

Z5 = Kitchen and Garage Pir

Z6 = Landing and front room Pir

Z7 = Main bedroom and Back room Pir 

Z8 = Down stairs Upstairs PA.

 

 

cables under carpets ?

52 minutes ago, Amit said:

External bell tamper not Linked.

internal bell is a speaker, i have checked the wires to external bell with a meter and all 5 cores tested ok.

Yes I do suspect external bell but passes bell and strobe test.

 

Z1 =Front door contact.

Z2 = Hallway Pir

Z3 = Reception Pir

Z4= Dinning Pir

Z5 = Kitchen and Garage Pir

Z6 = Landing and front room Pir

Z7 = Main bedroom and Back room Pir 

Z8 = Down stairs Upstairs PA.

 

 

You wire the pir incorrectly near keypad?

6 hours ago, Amit said:

Scantronic 9651 alarms even when on installer mode, keypad does not show any faults or fault code, on log menu no fault activity shows, all voltages and tampers working ok, is this apanel fault? 

After reset and on user mode alarms. but again no fault code on keypad, again log does not show any faults.

What you mean after reset ?

14 minutes ago, al-yeti said:

You wire the pir incorrectly near keypad?

What you mean after reset ?

user code reset,not full reset. tamper to pir,s  wired ass global tamper in series

Pir,s are texacom compact pir, checked for tamper loop on each pir back to panel and ok