Gardtec 800 816 Installation Manual

[al-yeti]

On 28/09/2018 at 14:04, LeadAcid said:

As above, has anyone got the installation manual on .pdf? Cheers.

After visiting Google I found it available after about three seconds , so how can you say no one helps you dude 

 

They just follow forum rules no manuals no codes etc unless it's user end related 

[norman]

13 hours ago, LeadAcid said:

Since joining this forum I have offered to go out of my way to help others but have received no help in return.

You've made a grand total of 6 posts? (not sure if you've re registered)

 

I'd hazard a guess @ an old Briggs, CBS, Sandal or Lofthouse system?

[PeterJames]

8 hours ago, norman said:

You've made a grand total of 6 posts? (not sure if you've re registered)

 

 

Haven't really gone out your way either.

[LeadAcid]

2 hours ago, PeterJames said:

Haven't really gone out your way either.

I offered to travel all the way to Blackpool (90 miles) and meet one of the TRADE members on here to unlock some Gardtec motherboards for him (locked in engineers code). But he didn't want that, he just wanted me to tell him how to do it, which I wasn't happy with as I didn't know how legit he was. But I was prepared to do this for him FREE OF CHARGE. If that's not going out of your way to help someone then I give in!

 

[LeadAcid]

11 hours ago, al-yeti said:

After visiting Google I found it available after about three seconds , so how can you say no one helps you dude 

 

They just follow forum rules no manuals no codes etc unless it's user end related 

I also found the manual using Google before posting here but when downloaded, the left hand edge of every page was missing which isn't noticeable in the thumbnails. 

[norman]

21 hours ago, james.wilson said:

if your an installer apply for trade.

This ^^

[sixwheeledbeast]

 

1 hour ago, norman said:

This ^^

I can confirm this manual is available for trade members only.

We also encourage any manuals or manuals requests be posted in the Downloads section of the site where there is version control, search and filter features.

[PeterJames]

10 hours ago, LeadAcid said:

I offered to travel all the way to Blackpool (90 miles) and meet one of the TRADE members on here to unlock some Gardtec motherboards for him (locked in engineers code). But he didn't want that, he just wanted me to tell him how to do it, which I wasn't happy with as I didn't know how legit he was. But I was prepared to do this for him FREE OF CHARGE. If that's not going out of your way to help someone then I give in!

 

No evidence of this in your posts. If whoever asked you was Trade and had the " Full Trade Member" in their profile they have been screened as trade.