3 hours ago, norman said:

Is that PCB in the case upside down?

No I don't think so, and I think it is the micro x line from looking at PDF online. 

How do you get the screw in when it's adjacent the ceiling? 

Remove the small screw on the pcb and pull board away and fix the the rear of the housing to the surface and re attatch

13 minutes ago, Muttsnutts said:

No I don't think so, and I think it is the micro x line from looking at PDF online. 

So you know the model all sorted 

2 minutes ago, al-yeti said:

So you know the model all sorted 

Yep  all for the help.

7 hours ago, Muttsnutts said:

 

looks a pile of poop...

 

replace with an dt8016 or an Iwise DT,

 

the toolstation pir is tat

1 hour ago, Muttsnutts said:

Remove the small screw on the pcb and pull board away and fix the the rear of the housing to the surface and re attatch

No, the casing screw (hole) shown @ the top of the photo.

Edited July 19, 20178 yr by norman

1 hour ago, norman said:

No, the casing screw (hole) shown @ the top of the photo.

Umm it's the small phillips one just to the left of the red led ? 

no the lid screw, not the pcb screw

You Deffo have to remove the small pcb screw to fit it to a wall. 

 

Installation Instructions
1. Open the housing by removing the front cover. To do so, press the tab located on top of the detector.
2. Remove the PCB by unscrewing the PCB screw from the rear of the protective plastic casing. Note: Do not touch the face of the PYRO sensor.