RL2 by the looks of it which looks to be linked closely to the loop circuit

Whats it programmed as?

Whats it programmed as?

Not sure I understand the question

Not sure I understand the question

Possibly as above the relaybhas been programmed to do something under certain conditions or something , if that's possible check what the relay is set to do

I dont see anything relating to relays, but i will have another look when I get a moment

On the panels I know the outputs/relays are programmable id guess its set to do that

Are you shure the loop is ok and its not the panels loop isolators operating.

Im only running with 2 detectors on a small run of cable, i will swap the detectors over with some spares I have

From what I can gather the Gent nano panel is very cut down from the stuff you guys probably deal with and as such quite straight forward menus, but i will look again and see if I can see anything thats responsible for this clicking

I might also try the loop with no detectors at all in the bases and see if it still clicks

i still go with its a heartbeat for a bms low end

Are you shure the loop is ok and its not the panels loop isolators operating.

 

If you have it on a bench and the loop is made up of a couple of meters of cable, the loop may be to short and resistance of the loop is not enough for the panel.