Nova-Security

So he did in post 5 Dose every DIY (as its in the DIY section) have 3 7ahr batteries laying around ? Would have expected to see + Batt Miss

battery could be knackered, seen batteries with 12v on meter but current reading less than 1amp, cells had gone low resistance, check battery resistance with meter.

The are classed as Emergency Door Release, nothing to do with fire. As you stated if the door needs to be used in an emergency what do they do.

loads of Btecs & city & guilds http://www.tavcom.com/training-courses/intruder-alarms/

As above, make sure the keypad is set to audible in the keypad menu

Should this not be in trade?

Thanks, will have a look.

easy to use, create and to link to a db

Yes

Yes, been using it for years time for a revamp its what alarm master use https://www.creativitycorp.com/

Anybody got a decent service checklist i can have a look at for cctv / access. Just in the middle of rewriting ours for, so far intruder has been cut down to 12 points which is now going to be cut down to 11 as i think the last two are the same question.

ACPO policy (or what they are called now) any policed call must be reset by an engineer or managed reset

Power supply

As above but redcare secure SIA 3 if redcare RS485 is supported on the flex

Because they are in to plaster or plasterboard. Always challenge them here, its how you learn.

NSI say suitable fixings, staples are suitable depending on use.

Correct,

Last inspection was told they are ideally for cables across entry routes / fire escapes. funny how things change.

http://www.sendtech.co.uk/Mobi_control.shtml ignore the one above, http://www.controlbyweb.com/

if its a cavity wall fish it.

Seen one of ours on a list that a certain distributor / manufatory gives photocopies out to people, funny really as its a code we use for a subbie to put in to set a system up, then when we go to commission the site its changed. Not used that subbie since and will never use again as the trust has gone. And we know who it was as every subbie has there own code issued. Agree with that,

Galaxy RSS has a place on comms server where you put your UDL code

We went to take over a large site with a G3 on it, had engineers code changed by losing company connected up the laptop, and it wouldn't connect. in the g3 panel there is no pace to program the downloader ID or system ID so unless you know them you are not connecting to the panel unless you crash it and reprogram it. When we install a new system them site is then sent to our server which generates a system ID and puts our downloader ID in to the panel, then if we take a laptop to that site the only way to connect to it is to export the file from our server and import it on our laptop. Might of missed something but where on a G3 can you programe the downloader ID ?

Password, system ID and site ID required in filled in, if its a new site UDL password will do for G2 but once a G3 connects the software gives it a system ID If you do a automated call via RSS it creates a virgin site and gives the panel a system ID which the only way to get round is to crash the panel, unless you have the system ID