al-yeti
-
Posts
9,443 -
Joined
-
Last visited
-
Days Won
129
Content Type
Profiles
Forums
Events
Downloads
Gallery
Blogs
Everything posted by al-yeti
-
You said your selling up , and handed most your stuff over ? I think your an imposter
-
What values are the resistors? As you used the tamper one to put on the panel All I am saying if you can't clear the fault with a simple resistance, then your eol must be set different to what your putting in and it doesn't matter what sensor or cable your using , all of no consequence What happens if you move a sensor from further up to zone two or three , it should clear the fault and send the fault to other Rio output
-
Another thing , show a picture of how one of your pirs is working , how is it wired and what resistors are inside it This will help you why your not able to clear the fault on z2& z3
-
In your picture above zone 3 shows the wiring sheath isn't removed and can be a problem , did you correct that?
-
Going to basics If your remove the wiring and put a resistor in the correct place it should clear any fault that is present there
-
Must mean zone 2 was being used as a sab tamper maybe? But earlier you said it was a PIR So when you say you get +sab and 1002 are you sure these are not separate faults and your not confusing matters
-
You got a picture of where you put resister?
-
Classis is me lol So enable in menu 48 , and then enter engineer code But OP more than likely you don't have it so try the resistor and then you might be lucky if it's all user reset
-
Alien DVR 654K - cannot stop beeping following power cut
al-yeti replied to Alan Richardson's topic in CCTV & Access Control
You ok yeah? Lol -
Thought it has to be enabled ? While your stuck get a resistor and put it across 1k and it should stop it from throwing the error until you work something out
-
Think he selected wrong forum , he discord is what he uses normally
-
You using power Rio?
-
SimpleGuy
-
Alien DVR 654K - cannot stop beeping following power cut
al-yeti replied to Alan Richardson's topic in CCTV & Access Control
Not really Common for fan to make the noise If hard disk doesnt spin up common for hd failure rather than PSU All vague unless you test it all of course , you don't need logs and menus to test that stuff -
So it means setting b?
-
This is UK , we don't read anything , especially manuals until we desperate
-
But we already told you where to start? Are you basically saying you don't have a clue how to find the manual to atleast wire the keypad to the control panel If you can't get that bit done , I would forget Bout this .....
-
Insurance? So they don't mind you DIY installing not know what your doing ?
-
They make good money then ?
-
Then go for the door sensors marked 1001-1004 which will be the first four zones on the board (1003 not being used it looks)
-
Leave coms til last , mount your panel and keypad , c078 , and the coms boards should already be mounted hopefully Switch on and see what faults you get, work through one by one
-
You should leave this for engineers to sort out ......
-
You know ply will rot But you get sometime out of it lol
-
Welcome As long as Amazon and Google don't tie up, it will be a nice mess for a long time lol
-
This is the second bell? Or all wired up inside the control panel with both cables I never had an issue the plastics on the Delta bell , unless that backplate tamper screw has snapped the tab maybe possible Or as said Bel is faulty but then I would swap the modules round if easy for you , that way you will know it's not the bell module as fault should follow Leaves you with plastics and cabling issue
