al-yeti

All that spare time you can get it sorted

Picture of sensor? With cover off

Have you measured the battery voltage with good meter , not Chinese stuff that will give you wrong readings For the sake of £4 change battery see what happens

No need , line a bunch of London rats on leads keep them hungry

Put four cam's high for overview wide picture and four cameras low for recognition as mentioned , and stick few more up around will look hardcore

Low battery?

Doesn't selfmon provide reports?

For diy pyronix enforcer, scrap the 9800 The other wired versions you will end up calling an engineer in anyway

He means an engineer "approved " is very vague

Sounds to me it's been shut off because of faults , and even factory defaulting won't help you, even though that info isn't not given out on this site If it was working most systems just sit there happily in standby and if shut down because whatever fault occurred they didn't want the expense to fix it

If you know what your doing just sawp it live Otherwise disconnect all four from panel , it's easy to take off 12v at PC end and still make a mistake You have fire extinguisher nearby?

Can you make a time capsule post? So a guest can open it in 60years?

The grab claw doesnt have a TX

One of these? While was doing a "h" with bit plumbing refurb stud wall etc it was taken out

Lol alarm monkeys keep them in service Aslong as possible

Are used ones not cheap on eBay?

You mean the power light?

Doesn't matter what you say 1. Faulty bell 2. Cable fault 3. Panel fault 4. Installation fault 5. You need an exorcism

Water on pcb

Overpriced nothing to do with quality lol

Picture Is it under an eave ?

You sound like some mad scientist , just to keep up with diverting topics

Yes rear tamper switch , do you have pebble dash etc on the wall, or bell box is mounted on an uneven surface , the only way you can adjust it is by bending the metal switch lever , but you have to be careful when mount back so it's tip isn't catch the wall as it should be still be flattish against the wall Some bell box's have an adjustment screw , I am sure this doesn't No dont disable tamper , pointless having the box then , just fix how it's mounted The side screw is what pushes the switch

Where you get second set of tags Default whole system and start again

Sd3 overpriced but I suppose doesn't matter if customer paying and doesn't care ........