al-yeti

Are they a registered ssaib or nsi company? Do you have log of dates and time of problems and have they replied to you in writing each time?

Looks as though it will compete well with the enforcer , of course enforcer might be slightly better , but the market it's driven to is the issue

I almost thought of taking your side until you said this lol

Depends if budget is low then not much rate eh?

£200 for a pro £80 for a house basher I am a posh house basher £300

Well on a side note I thinking of going into monitoring , it's all free ,so far i can get cia mi5 Scotland yard mi6 FBI all keep an eye on my house , just got to keep four corners of my house covered with green flag up and moon on it No one will come near it , you think it will catch on?

Haha i in ayes mate

Fa on wireless pir Honeywell , battery? Unlikely I would also look at what's in the room that might be chasing the fa, pointing at window? Balloon lol

That's bell tamper on visonic?

Welcome to southall

Can't give it out on this forum, but why not just pay an engineer to reset them for you, normally small one off cost

Did you programme that zone? Is there no option to make the zone bell tamper ?, then you need to look at your resistor placement

So your saying some or most manufacturers put in a clause undercover to keep there products from failing regs at times because they know there products can't meet the regs so add on a few hours and it's all sorted Perhaps Hardcore i reckon my dual path pstn gsm will report within minutes (if i got signal of course )

Pet pirs seem pointless to me, be prepared for reposition and messing about , cats dogs seem to jump in the wrong spots and weird places All the pros would say go perimeter protection instead and perhaps have pirs where you would always remember to close off the areas so the pet can't go there and so on

Enforcer with wired keypad with mashed up menu I like the keypads better than Hkc but having taken apart an enforcer can't quite figure what everyone means by "cracking little panel" might be to do with plastics

You been filming my installs?

Good condition , offers

You do understand your not supposed to use all six wires , only two for power and two for the zone

Hangon oddly enough on texecom paper

So you have one leg on an alarm contact and other leg on a tamper , can't be drawing it lol

You obviously have to use the correct terminals in the Pir also , not sure what model you have , but example you may have 10 terminals , you will be using two for power and two specific terminals for using eol , at least that's on some

Whatever resistors you use in the pirs need to be set in the panel via keypad yes

Yes you don't need global tamper if your using eol

If your out? Sleeping?

Does work , especially advertising companies they get a junior or any staff member to sign and your stuffed