Am I the only one finding Pyronix gear becoming more and more unreliable? I constantly seem to be having issues with them at the minute, particularly with the WiFi connectivity on Enforcer panels/HomeControl2.0 app.

I've currently got yet another v11 WiFi issue. The panel says I'm connected to the internet, but pyronixcloud.com and HC2.0 say I'm not. This one's only been in 5 months from new - and that was to replace one that was faulty from the factory...

I really am tempted to just switch everything to Orisec. The only reason I haven't yet is out of habit, but there's no point staying with Pyronix with the high level of issues I'm having...

I've an Orisec CP-20 in my house, wired bell, speaker & 4 pirs

The wireless keypad is shite, the wireless contact on the front has a pyronix magnet as the orisec one is shite.

The app is shite, the udl software is also shite

Edited 13 hours ago13 hr by MrHappy

59 minutes ago, MrHappy said:

I've an Orisec CP-20 in my house, wired bell, speaker & 4 pirs

The wireless keypad is *****, the wireless contact on the front has a pyronix magnet as the orisec one is *****.

The app is *****, the udl software is also *****

When is the hub or q70 going in

Edited 12 hours ago12 hr by al-yeti

8 hours ago, al-yeti said:

When is the hub or q70 going in

Probably never,

I've only 2 x 10270 & a hub. Not really sure if I like them

12 hours ago, fatman said:

Am I the only one finding Pyronix gear becoming more and more unreliable? I constantly seem to be having issues with them at the minute, particularly with the WiFi connectivity on Enforcer panels/HomeControl2.0 app.

I've currently got yet another v11 WiFi issue. The panel says I'm connected to the internet, but pyronixcloud.com and HC2.0 say I'm not. This one's only been in 5 months from new - and that was to replace one that was faulty from the factory...

I really am tempted to just switch everything to Orisec. The only reason I haven't yet is out of habit, but there's no point staying with Pyronix with the high level of issues I'm having...

poss router stopping you try fixed IP address on the enforcer and open the ports required on the router 443 25000 25010 top of my head

most admit couple of my jobs ive fitted a LAN card and used them home switches to route the network to the panel

dont use it but is the wifi 2.4Ghz. You may need to enable a seperate non 5Ghz access point. Can usually be set in the router. What BB / router is it. Sky and EE can be a pain