On 27/04/2025 at 21:04, ian.cant said:

 

Thats half an amp in my book 😉

Theres 1000 mA to an amp not 100 550mA would be half an amp (well over half an amp)

On 29/04/2025 at 18:47, PeterJames said:

Theres 1000 mA to an amp not 100 550mA would be half an amp (well over half an amp)

You are not reading what he typed correctly he typed "with the panel and sensors pulling 0.55 A" 

Now there was no mention of mA  so 0.55A no matter how you try to dress that up is slightly over half an amp.

He may have made a mistake but either way what he typed is 0.55A not 0.055A which would be 55mA  😉

On 30/04/2025 at 22:10, ian.cant said:

You are not reading what he typed correctly he typed "with the panel and sensors pulling 0.55 A" 

Now there was no mention of mA  so 0.55A no matter how you try to dress that up is slightly over half an amp.

He may have made a mistake but either way what he typed is 0.55A not 0.055A which would be 55mA  😉

I cant believe I missed that I went back and re read it as well just to be sure 

47 minutes ago, PeterJames said:

I cant believe I missed that

 

dementia, quite common at your age....

3 hours ago, MrHappy said:

 

dementia, quite common at your age....

I suppose it makes a change from the gay jokes 

On 02/05/2025 at 15:03, PeterJames said:

I cant believe I missed that I went back and re read it as well just to be sure 

It is usually me that gets it wrong, I read it quite a few times too, couldn't believe I was right for once 🤣

When I replaced the 12V 7Ah battery in my Texecom panel, it took around 24 hours to fully charge. Most panels trickle charge at a low rate, so it’s normal for it to take a while. Just make sure your panel isn’t showing any battery fault after a day or so..if it is, double check the connections or battery health.

As JW stated the charging rate is in the standard.

Larger premier panels have a charging rate selection jumper so you can adjust the rate depending on the battery and make sure it conforms.