Hi all, 

 

I have a securitysystem g2-20 i have a vaiani siren, and wired to panel, but when i put blue cable in - then it will go off, when there is no alarm, i have some picture below.

 

 

Greetings Michael.

Your picture doesnt show what the terminals are ? The wires are in the way

There is no wires in the way, the wire from panel and siren have i make a pictures.

 

3 hours ago, MichaelZoolingen said:

There is no wires in the way, the wire from panel and siren have i make a pictures.

 

Because the bell isn't a trigger type 

 

You would need a relay for this , so the panel needs to trigger the relay and power provided to the bell via +and-. The two t terminals probably just a tamper switch

How ever if you look at the panel manual and buy a speaker instead it will work better for you and put on speaker terminal , don't however put this bell on the speaker output 

9 hours ago, MichaelZoolingen said:

There is no wires in the way, the wire from panel and siren have i make a pictures.

 

I cant see what it says under the grey wire 

and I cant see what it says under any of those terminals 

T

+

-

T

T

52 minutes ago, norman said:

T

+

-

T

T

That's what I could see but lots of T's didnt make any sense 

Suspect the two T's are just a volt free switch. 

On 10/08/2022 at 07:13, MichaelZoolingen said:

There is no wires in the way, the wire from panel and siren have i make a pictures.

 

All connections are correct   blue should go to the bell terminal 

 

Apparently no one here worked on a galaxy G2 I guess?

Edited August 11, 20223 yr by Imnotshankled

I have on sire +-TT and on panel Bell +12 v, and T and - BELL.