Texecom Premier Elite - all zones active

[nunosga 0]

Hi,

6 months ago I  installed a Texecom Premier Elite with 6 Texecom Pirs, in my house.

Everything worked fine until last week. All of the sudden when trying to arm I get a fault message for every zone: they're all active.

But It worked fine until then...

There were not other faults or problems I remember.

Any ideas on how to solve this?

[sixwheeledbeast 399]

What model panel? Wired or wireless?

 

[nunosga 0]

Wired. Premier Elite 24

[james.wilson 610]

Pir power dead? 

[sixwheeledbeast 399]

No voltage on all the PIR's? They are poly fuses one maybe hot.

[nunosga 0]

Corret, one is hot! 

What now?

[sixwheeledbeast 399]

Find out why...

You have a short on a cable or possibly some issue with some equipment.

[nunosga 0]

I mean, a poly fuse is hot inside the control panel. See picture:

[sixwheeledbeast 399]

Yes exactly and the red light is indicating that it's triggered too.

[PeterJames 499]

Take everything out of the 12v and put it back one by one until you find which cable is causing it 

[nunosga 0]

I did just  that and found the problem. Solved!!

Thanks a lot!! Back on track.

 

[james.wilson 610]

What was the problem for future readers? 

[PeterJames 499]

21 hours ago, james.wilson said:

What was the problem for future readers? 

Im guessing it was one of the 12v circuits shorting? but its just a guess

[sixwheeledbeast 399]

My guess is an Arduino or some other SBC?