3K3 doesn't support multiple devices on one zone would need to be double pole or 4K7/2K2

the multimeter shows reed 1 at 3.3k and reed 2 on 5.2k. so I'd have to up the reed1 resistor?

It appears the international series has allsorts of weird SEOL configurations look in the manual for wiring zones take note of the parallel "zone doubled" config you have to apply this to each circuit you wire this way.

If you have moved zones around in the panel this will be setup incorrectly.

I removed all sensors. I've added resistors to all zones (please check the pics if this is right?) and reset to default. I've programmed date and time. This is what I've got now:

99 to leave engineers?

If so all zones and tamper is active

that is out of engineers. Engineers has all 8 lit up. I tried tamper disable pin on the controller, (has a 3 jumper pinout for Tamper Disable), same thing.

21 minutes ago, Shadrack said:

that is out of engineers. Engineers has all 8 lit up. I tried tamper disable pin on the controller, (has a 3 jumper pinout for Tamper Disable), same thing.

So if you disable tampers , then might be as Swb says the seol config and resistor combination?

Well I did nuke config back to defaults so it shouldn't be an issue? also I removed the broken reed and removed the wires so no more 2 reeds on 1 zone. as it is while I type this, all sensors removed, replaced with resistors.

May not be setup for resistors as default

8 minutes ago, Shadrack said:

Well I did nuke config back to defaults so it shouldn't be an issue? also I removed the broken reed and removed the wires so no more 2 reeds on 1 zone. as it is while I type this, all sensors removed, replaced with resistors.

Put wire links instead of resistors and see if anything changes