1 hour ago, al-yeti said:

Correct , with resistors in place 

 

Is it a door contact with no tamper ? 

Good bloke you can then also get an RF card later I believe and have wireless zones , unless you already have that

 

Already have the RF card, see below!

 

19 minutes ago, al-yeti said:

Sounds ok 

 

Great.

 

All seems done but I now have a tamper on the RF PORTAL 105.

 

I don't have any RF Detectors connected?

 

33 minutes ago, RevolvingSteve said:

 

Already have the RF card, see below!

 

 

Great.

 

All seems done but I now have a tamper on the RF PORTAL 105.

 

I don't have any RF Detectors connected?

 

Did you fit the spring in the portal?

In the flex you fit a jumper on the tamper header of the portal. There are a few unused jumpers on the existing headers if you don't have any spare.

On 19/01/2019 at 20:47, GalaxyGuy said:

In the flex you fit a jumper on the tamper header of the portal. There are a few unused jumpers on the existing headers if you don't have any spare.

 

Could you elaborate? Im not at the house until tomorrow but will check it out.

On 19/01/2019 at 18:28, al-yeti said:

Did you fit the spring in the portal?

 

Again, you'll have to elaborate a little...

I love galaxy but that had to be the fugliest rkp available. 

5 minutes ago, norman said:

I love galaxy but that had to be the fugliest rkp available. 

 

You mean the panel or the install  Its on a temp wall for now until the room is done

 

No, I meant the actual design of it, it's hideous and looks like a school electronics project. 

On 19/01/2019 at 20:47, GalaxyGuy said:

In the flex you fit a jumper on the tamper header of the portal. There are a few unused jumpers on the existing headers if you don't have any spare.

 

Thats the only wire I have connecting the RF to the board

1 hour ago, RevolvingSteve said:

 

Thats the only wire I have connecting the RF to the board

Because it's in main box fit jumper next to the top switch 

On 19/01/2019 at 20:47, GalaxyGuy said:

In the flex you fit a jumper on the tamper header of the portal. There are a few unused jumpers on the existing headers if you don't have any spare.

As Mr galaxy said