Not yet. Good idea, i'll be disconnecting the mains and battery tommorow when  I do the bell.

Think the enforcer monkeys on extra holidays so keeping you busy until they reply lol

You sure you dont have anything programmed into the arc settings?

Also if the zems, ewd and detection are all powered off the panel you are overloading the power supply. Are they the mains powered zems with their own battery or the small ones?

Edited April 5, 20188 yr by petrolhead

5 minutes ago, petrolhead said:

You sure you dont have anything programmed into the arc settings?

Ah you see dude turns up and remembers all these terms , arc settings as he says or a Digi mistake somewhere

 

Or reboot might work lol 

 

Out of interest why would you fit an enforcer when a euro 46 is the more appropriate panel for the job?

Pretty sure it says 485 fail when it cant poll a zem, comm fail would be signalling

Edited April 5, 20188 yr by petrolhead

How many h/w pirs fitted? 

As above sounds line to much being driven off the panel.

Has all detection been successfully walk tested? Voltages at detectors?

 

 

2 hours ago, grantc said:

How many h/w pirs fitted? 

As above sounds line to much being driven off the panel.

Has all detection been successfully walk tested? Voltages at detectors?

 

 

For Comms issue?

2 hours ago, petrolhead said:

Out of interest why would you fit an enforcer when a euro 46 is the more appropriate panel for the job?

Pretty sure it says 485 fail when it cant poll a zem, comm fail would be signalling

Come on man , enforcer is more DIY friendly no? When doing wireless though....

Neither is a diy panel. Doesnt stop arseholes selling them to diyers though.

8 minutes ago, petrolhead said:

Neither is a diy panel. Doesnt stop arseholes selling them to diyers though.

Diyers fitting this gear hardcore 

 

 

Whoever sold it to you must have a technical helpline. Just call them and have them talk you through it while your at the keypad.....