Euro 46 app panel

[bazza1981]

just contacted pyronix they said eol on two devices will work

2 Contacts to 1 Zone 4k7_2k2.pdf

[sixwheeledbeast]

3 hours ago, sixwheeledbeast said:

You can't, without bodging the shunt loops around with spare pairs.

 

 

Marvellous, lets hope the intermediate wire isn't crushed or shorted, which would read as a permanent secure zone at the panel.

Well done Pyronix for having this bodge documented.

[MrHappy]

4 hours ago, datadiffusion said:

Yep as above it always threw me why people though you could 'chain' EOL then found out that gal supports it!

 

TS Menvier & early Premier did multipal eol devices

[MrHappy]

4 hours ago, james.wilson said:

no afaik only the galaxy supports eol like that

also the area mismatch iirc means you have things in areas but no keypad assigned etc

 

+ aslso

 

radio devices added but not zones not programmed / zoned programmed radio device not learnt

[Amps]

1 hour ago, bazza1981 said:

just contacted pyronix they said eol on two devices will work

2 Contacts to 1 Zone 4k7_2k2.pdf

 

Lol I can imagine our service engineers getting confused by that. Keep it simple is the moto!

[MrHappy]

8 minutes ago, Amps said:

 

Lol I can imagine our service engineers getting confused by that. Keep it simple is the moto!

 

I'd say its much easier way to do 2 devices  in series but use different resistor values?

Edited September 1, 2017 by MrHappy

[Amps]

18 minutes ago, MrHappy said:

 

I'd say its much easier way to do 2 devices  in series but use different resistor values?

 

We normally fit Knight G2 contacts that allow for this.

 

 

YEND74 MULTI.pdf

[bazza1981]

It's an old job with shock contacts is the document from pyronix not a good idea to use?

[MrHappy]

2 hours ago, Amps said:

 

We normally fit Knight G2 contacts that allow for this.

 

 

YEND74 MULTI.pdf

 

I reckon theres a easier way to wire double doors on a euro than their diagram 

[james.wilson]

17 hours ago, bazza1981 said:

It's an old job with shock contacts is the document from pyronix not a good idea to use?

you could use their diagram or use dp. 

best to not but u do have existing cabling to work with