Jump to content
Security Installer Community

9100 Won't Exit Programming Mode


mweetman

Recommended Posts

Thanks for all the great input. The tamper switch had actually been broken by the Service Company, & they had tried to fix it with tin foil & bluetack!

Luckily as the device was left in Programming Mode, I could reset the Engineer's code, & change the Tamper Smitch.

Then fixed the PIR (which had been disconnected by the Service Company), & fixed 2 Zones that we had to omit for the last 5 years (these were simple problems).

All is good now :-)

 

I have one further question that I can't fathom. The Entry/Exit door has a lock with a shunt. When the alarm is in Day mode, the lock USED to give a 2 tone (high, low) indication when it was locked. However, now it gives the high/low indication when the door is UN-Locked, & nothing when the door is locked.

 

I recall this happened once before, but didn't see what the Service company did to change this back to the 2 tones when locking.

Looking at the programming guide I have "9100/9105 Installation & User Guide", I can't work out what I need to do to reverse the behaviour.

Any tips appreciated, & once again, THANKS FOR THE FANTASTIC SUPPORT.

Martin

Link to comment
Share on other sites

Thanks for all the great input. The tamper switch had actually been broken by the Service Company, & they had tried to fix it with tin foil & bluetack!

Luckily as the device was left in Programming Mode, I could reset the Engineer's code, & change the Tamper Smitch.

Then fixed the PIR (which had been disconnected by the Service Company), & fixed 2 Zones that we had to omit for the last 5 years (these were simple problems).

All is good now :-)

 

I have one further question that I can't fathom. The Entry/Exit door has a lock with a shunt. When the alarm is in Day mode, the lock USED to give a 2 tone (high, low) indication when it was locked. However, now it gives the high/low indication when the door is UN-Locked, & nothing when the door is locked.

 

I recall this happened once before, but didn't see what the Service company did to change this back to the 2 tones when locking.

Looking at the programming guide I have "9100/9105 Installation & User Guide", I can't work out what I need to do to reverse the behaviour.

Any tips appreciated, & once again, THANKS FOR THE FANTASTIC SUPPORT.

Martin

lol

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.