richardthatcher Posted December 28, 2012 Share Posted December 28, 2012 Evening Guys, Was doing an install today on a domestic all was complete went to put cover on and then the bell box started making 3 noises stopped and then started again looked at LCD and it was saying 2-Wire Smoke FLT so discounted battery powered down system and powered up again the LCD was still saying the same after power up unable to get in with any codes. Shorted out all zones still same problem. Noticed that heat beat LED was off also but the network T/R was flashing. I am going to put another panel in tomorrow but wanted to ask if anyone had come across this before. Richard Link to comment Share on other sites More sharing options...
MrHappy Posted December 28, 2012 Share Posted December 28, 2012 link on the pcb? Mr Veritas God Link to comment Share on other sites More sharing options...
richardthatcher Posted December 28, 2012 Author Share Posted December 28, 2012 you mean the 2 wire jumper - that is set to disabled Link to comment Share on other sites More sharing options...
Oxo Posted December 28, 2012 Share Posted December 28, 2012 Did you default it on power up? Link to comment Share on other sites More sharing options...
norman Posted December 28, 2012 Share Posted December 28, 2012 default the PCB Nothing is foolproof to a sufficiently talented fool. Link to comment Share on other sites More sharing options...
alterEGO Posted December 28, 2012 Share Posted December 28, 2012 I don't even like answering the phone until the 2nd, **** doing an install. I'm guessing you defaulted the PCB? Link to comment Share on other sites More sharing options...
AdrianMealing Posted December 28, 2012 Share Posted December 28, 2012 Default on power up amealing@texe.com Head of Industry Affairs Visit Our Website Texecom Link to comment Share on other sites More sharing options...
Oxo Posted December 29, 2012 Share Posted December 29, 2012 As I said, thats the first thing to do. Even out of the box. As it could have been the one used a QC. Link to comment Share on other sites More sharing options...
richardthatcher Posted December 29, 2012 Author Share Posted December 29, 2012 defaulted it and still doing the same thing. Replaced the panel with another one with no wiring change at the detector, bell, or kp and programmed and working fine. Link to comment Share on other sites More sharing options...
jb-eye Posted December 29, 2012 Share Posted December 29, 2012 No smart comments here seems all kit has some idiosyncrasies Customers! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.