The soffits had been redone on one system so I could not get the lid off...

 

I have now progessed to butchering with an angle grinder

 

Edited June 4, 20205 yr by MrHappy

1mm bit? 

17 minutes ago, norman said:

You're a machine 

 

diamond 

Thanks sugartits, what about the grinder? 

diamond blade,  as it was in the machine

 

1mm would have cut squarer...

 

 

1 hour ago, MrHappy said:

The soffits had been redone on one system so I could not get the lid off...

 

I have now progessed to butchering with an angle grinder

 

Send it to texecom and ask for a refund    i dare you

1 hour ago, MrHappy said:

, ate pizza

Could you send me some im hungry 

Edited June 4, 20205 yr by Guest

Professional bell destroyer, cut so the tamper loops closed and you can access the terminals.

10 minutes ago, Logan said:

Send it to texecom and ask for a refund    i dare you

 

its older than you!

9 minutes ago, sixwheeledbeast said:

Professional bell destroyer, cut so the tamper loops closed and you can access the terminals.

 

cut a hole & pull the piezo's off

 

 

7 minutes ago, MrHappy said:

 

its older than you!

My syncro is older than me

Decent size holesaw does a good job too, done that a few times when you can't get the roofer out the bottom of a C Type. Saves pulling all the shattered plastic out the gutters and borders later...