Hi does any one know how to access the engineering mode on the pyronix conqueror panel ? I need to get zone two changed to access on entry but I can't find the info on any down loads for the panel only user down loads many thanks in advance for any advice 

Hi, sorry no codes are given out on here

I'm not asking for codes I'm asking for an engineer's manual down load 

4 minutes ago, phil039 said:

Hi does any one know how to access the engineering mode on the pyronix conqueror panel ? I need to get zone two changed to access on entry but I can't find the info on any down loads for the panel only user down loads many thanks in advance for any advice 

Best thing call a local engineer to reset you codes, should cheapish

 

Although I advise scrap it and change the panel for one thing more upto date 

I don't need to reset the codes tho I want to know how to change zone 2 to access without the alarm goin off every time I enter my garage 

Sorry but not default or programming information info is given out on here.

If you want to work on the panel yourself you can always contact Pyronix for the manual

 

But as Al-Yeti says its a very old panel and an upgrade would be a good route to take

Edited November 29, 20178 yr by aissecur

I don't need to reset the codes tho I want to know how to change zone 2 to access without the alarm goin off every time I enter my garage 

If codes etc etc can't be given out on here maybe some kind person may send me a email ? 

If its any help its the same programming as the Paragon E panel.

I look at the book for you.....

 

But I'd prefer you to tw@t it off the wall with a claw hammer & buy a euro mini or similar 

 

 

1 hour ago, phil039 said:

I don't need to reset the codes tho I want to know how to change zone 2 to access without the alarm goin off every time I enter my garage 

If codes etc etc can't be given out on here maybe some kind person may send me a email ? 

Requires codes either way , as above paragon e 

 

And twatting