Hi all,

 

Just moved into a property which has abacus alarm system installed. One of my lil ones decided to press the panic button and now the alarm will not set. I've tried resetting but on reading some posts on the forum I'm aware I need to reset the panic button.

 

The question is how do I do this? Do I need a special key? Any help will be greatly appreciated!!

 

regards 

 

T

there should be a key left by the unit or with you from the owners, if not pm me your address and ill send one in the post, a small shaped keyhole on the unit is where the key fit and you just twist the key to push the trigger button back to break the contact.

If your panic button looks like this, you can undo the two screws, take the front off and push the buttons back with your finger.

13 minutes ago, Jim Randle said:

If your panic button looks like this, you can undo the two screws, take the front off and push the buttons back with your finger.

 

You can damage a new type CQR PA if you remove the lid while triggered

3 hours ago, Titch007 said:

Just moved into a property which has abacus alarm system installed. One of my lil ones decided to press the panic button and now the alarm will not set. I've tried resetting but on reading some posts on the forum I'm aware I need to reset the panic button.

 

 

Have you tried to contact the installer they maybe able to supply the key for you as there are a few different types.

Mr Beast is right. I should have remembered. The older one's are OK to open. Jim

Yes take cover off , hope it's not engineer reset or something crazy 

As its an Abacus system, it will most likely be a very old PA button, so taking it apart to reset and put back together and then enter your code to reset system.