Ronnie Posted May 26, 2014 Share Posted May 26, 2014 You don't have to acknowledge the tamper if you are in engineering mode. You just need to 'esc' out and get the 'checking tampers' message. If you still receive the tamper warning for 0004, then the contact between the 'T' and '0V' terminals is not good. If you have a meter, then check these pins to ensure there is no voltage differential present. Ie. 0V. If you get 0V, then the board may be faulty, or be in some wierd 'Flex' state. you just cost me a call out! Link to comment Share on other sites More sharing options...
GalaxyGuy Posted May 26, 2014 Share Posted May 26, 2014 To Brussels ? Link to comment Share on other sites More sharing options...
Ronnie Posted May 26, 2014 Share Posted May 26, 2014 To Brussels ? and? Link to comment Share on other sites More sharing options...
james.wilson Posted May 26, 2014 Share Posted May 26, 2014 I'd ay you broke it. securitywarehouse Security Supplies from Security Warehouse Trade Members please contact us for your TSI vetted trade discount. Link to comment Share on other sites More sharing options...
ftikai Posted May 26, 2014 Author Share Posted May 26, 2014 Thank you GalaxyGuy, I just did what you said and I got 0V between T and 0V. I think I have one solution left: Cold Start (51.17.4) to set all settings back to default setting. Do you think that could be a solution? Link to comment Share on other sites More sharing options...
matthew.brough Posted May 26, 2014 Share Posted May 26, 2014 No I'd ay you broke it. www.securitywarehouse.co.uk/catalog/ Link to comment Share on other sites More sharing options...
GalaxyGuy Posted May 26, 2014 Share Posted May 26, 2014 Thank you GalaxyGuy, I just did what you said and I got 0V between T and 0V. I think I have one solution left: Cold Start (51.17.4) to set all settings back to default setting. Do you think that could be a solution? You have nothing to lose if you're going to have to swap the board out anyway. Link to comment Share on other sites More sharing options...
timmo66 Posted May 26, 2014 Share Posted May 26, 2014 What do you get if you meter between any aux positive and T? Link to comment Share on other sites More sharing options...
ftikai Posted May 26, 2014 Author Share Posted May 26, 2014 I solve "by accident" the "0004 AUX TAMPER" problem by setting all the outputs (1001 to 1024) to "spare" (latch) and output *99 to E/E Horn (latch), then restart the system. Thanks all! ... Note that this is the first time I have an alarm system and I find that the Galaxy Flex is nice piece of hardware, with a lot of software options. I got mine through securitywarehouse because it is not easy to find this kind of system open for diyers here in Belgium. Until now, I like it very much even though it is not newbie-friendly. Link to comment Share on other sites More sharing options...
GalaxyGuy Posted May 26, 2014 Share Posted May 26, 2014 I think that the system has detected that the T-0V jumper has been removed momentarily (yes, I hooked this wire by mistake by installing the phone input) Trying to understand the statement above. Did you connect your phone line to the T connection ? Your solution ^^^ sounds a bit odd as these are outputs and your fault is an input. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.