Search the Community
Showing results for tags 'Premier'.
-
I have got the Texecom Premier 48 with a Battery Fault. This has happened since we had a short power-cut one evening. I have logged into engineer mode and looked at the status of the battery. The battery has 13.6v and is fully charged. I have done a walk test to make sure all the PIR’s and Door Contacts work. What I have displaying on the LCD Keypad is ‘System Alerts!’ and ‘Battery Fault’, how can I stop these messages from appearing?
- 33 replies
-
Hello Everybody, I'm hoping you can help me with what is (hopefully) a relatively simple fix; I upgraded the firmware on my premier elite 24 panel from 2.(something i cant rememeber) to 3.2. Since doing so when i press the area button on my control pad in the hall the system goes to part arm 2, The system is set into 2 areas; Area A = Ground Floor and Garage Area B = First Floor The control pad in the hall is set to Area A&B but I havent got the "use keypad areas" box checked in wintex, I tried it and it made no difference. The second control pad is in the second floor landing, This is set to area a only, the idea being that I set the alarm from the second floor pad at bed time and we can roam the first and second floors (no sensors on second floor) and then either dis arm from second floor in the morning or go down stairs and the hallway sensor will start the entry timer. The Parts arms are as follows; Part arm 1 - Doors and Garage Part Arm 2 - Bedtime - Seperate to only activing area A from second floor pad Part Arm 3 - Garage Only So before i updated the firmware it all worked beutifully, I press area in the hallway when leaving the house and the whole house was armed, and i pressed area on the second floor pad at night and only the grond floor and garage was armed. Like i say though, when i press area on the ground floor pad now it automatically goe's to part arm 2. I even change the configurations on part arm 2 so it was the garage only setting and part 3 was the bedtime incase something in the zone settings was confliciting but it made no difference, even with the garage as part 2 when i press area it still auto's to part 2. HELP PLEASE!!!!!!
- 25 replies
-
I have a relatively 'smart 'house' which is connected to my phone and a number of peripherals around the house. I have built most of it myself and want to know if I can disam a Texecom Premier alarm using a discrete input from the 'house system'? I couldnt see anything obvious as the zones are the only input (I have no communicator board!). There are plenty of outputs which I have programmed to output on alarm to the 'house system' to perform various tasks. Its the ability to disarm Im a bit stuck on. Any ideas??
-
I used to be selfemployd before retirering and mostly i used to instal Scantronic panels at that time and lately I have been interested in the Texecom range. Hope to be of help in this forum
- 4 replies
-
- scantronic
- texecom
- (and 8 more)
-
Hi guys, Has anyone got any advise regarding the Texecom wireless keypads? I have recently installed a Texecom Veritas R8 control panel and intended to have two LCD RKP's, hard wired into the system. One of these RKP's is working fine, but the wire to the second is damaged and now that the house is decorated I don't want to chop into the plaster. My best solution would be if I could use a wireless keypad at this location. I am guessing that I would need a wireless receiver to then run the signal down a wire into my R8 control panel. Has anyone got any experience of adding a Texecom wireless RKP to a wired Texecom system and do you have any advise to give? Many thanks.