ladybreaker

It worked Thank you very much Simlec

Thanks , You mean page 72 manual for the premier 88 will try and report back Thanks

Yes engineer code works

Thank you all for your input Correct panel with corect firmware is set for each one in wintex , and other company programmed the panel in 2002 and I do have the engineer PW that was changed at that time . So I'm assuming that the UDL PW is the last 4 digit of that PW , am i rigt ?, unless a new UDL PW can be changed independently to the engineer PW ! I know it is not going to work to copy all settings from one firmware to an other but I just wanted to printout the premier88 for a quick elite 88 programming as per old panel. (28 zones) I was not aware about the lock out after three wrong attempt. What about changing the wintex port speed from the default 4800

No I'm upgrading from premier88 2002 to elite88 2015

Hello everyone, I have got my new elite 88, I tried with the USB com to connect and was successfull to read data But have problem connecting with my premier88 I jst mange to get date of installation and then it shows communication error I tried ##REMOVED## as udl password also tried tha last 4 digit of engineer password but no success Do I have to remove main power supply ? This is a system been installed in 2002 and i need to read configuration to pass on the new elite 88, can the UDL be set to anythig from ##REMOVED## or last 4 digit from the engineer code.. According to the manual if i press ##REMOVED## Thanks if you can help

I used to be selfemployd before retirering and mostly i used to instal Scantronic panels at that time and lately I have been interested in the Texecom range. Hope to be of help in this forum