Hi all

 

I've just been trying to demo out my predominately wireless ION-40H system. The only part which is wired, is the sounder.

 

Most of the connections have a direct label in the control panel, however, i'm getting confused over the ENG input which appears on my siren. The manual says, output of type "installer on Site".  However, i cannot locate a relevant connection on my control panel

 

I've attached manual screenshots of both the bell inputs and my control panel diagram.

 

 

Any advice is much appreciated.

 

Thank you

 

 

 

There won't be a dedicated one, it means an output needs programming to that type.

Should work fine without it.

 

@sixwheeledbeast thank you. I will install without it. 

Logic would say if you have enough wires, stick a wire in everything deal with it at the panel end later...

From a DIY POV anyway...

8 hours ago, rpatel2 said:

@sixwheeledbeast thank you. I will install without it. 

As swb says stick a wire on it , and if you ever want to disable tampers some bells require to be connected temporary to 0v or something like that , then you can open bell without the siren going off or something like